Evaluation of sexed semen-based artificial insemination in Tharparkar cattle under organized farm condition.

Sexed semen facilitates additional female calf production for the expansion of a herd at a faster rate and also curtails the surplus production of unwanted male calves. A study was conducted to evaluate the performance of sexed semen in indigenous Tharparkar cows based on 114 artificial inseminations (AI) performed at natural oestrus using two protocols i.e., single AI (n = 48) and double AI (n = 66). Overall, the first service conception rate (CR) was significantly higher in double (53.0%) than single (33.3%) AI protocol. The odds ratio of conception rate in double AI was 2.26 (χ2 = 4.4, df = 1, p = .04) with respect to single AI. The time that elapsed since the detection of oestrus to insemination was also analysed. In a single AI protocol, the CR was higher (p < .05) at 16 h (54.6%) than insemination at 8 h (27.0%) following the onset of oestrus. Yet, the CR using double AI protocol did not differ (p = .73) significantly when AIs were performed either at 8 h and 24 h (51.9%) or 16 h and 24 h (57.1%) post onset of oestrus. Besides, like the single AI protocol, the parity of the animals also influenced the CR, being higher in heifers (n = 22) than those of parous (n = 92) cows (72.73 vs. 40.43%, χ2 = 7.48, df = 1, p = .006) in the present study. The odds ratio of conception in heifers was 3.93 with respect to parous cows. Overall, the birth of female calf was 91.7%. In conclusion, the present study indicates a future promise of the sexed semen for the production of more female offspring from Tharparkar cattle.

Post processing of low cost Aligners fabricated by additive manufacturing process to enhance the surface quality and functionality.

Additive Manufacturing (AM) processes have ample advantages compared to traditional manufacturing processes, including mass customization, material efficiency, bioprinting, and fabrication of complex geometries with reduced lead time. Despite such benefits, it suffers most from staircase effects that deteriorate the fabricated part's surface quality. Nowadays, additively manufactured aligners are suitable for treating malocclusion and temporomandibular defects of teeth. Fused Deposition Modelling (FDM) is one of the best substitutes for clear aligners production to reduce per-unit cost. Glycol-modified Polyethylene Terephthalate (PETG) is opted as the material to fabricate the clear aligners due to its biocompatibility and non-toxicity. However, the poor surface quality of the additively manufactured is a major challenge in developing clear aligners with the FDM. A novel experimental setup is designed and developed to enable Chemical Vapor Smoothing (CVS) to enhance the surface quality of the clear aligners. Furthermore, based on the Surface roughness, the comparison is made between the surface quality polished with various chemicals (namely methylethylketone (also known as 2-butanone), toluene and, cyclohexanone). Moreover, Response Surface Methodology (RSM) is used to analyze the impact of different process parameters (i.e., the chemical volume, exposure time, and workpiece orientation) on the surface quality of the clear aligners. Moreover, RSM shows that the impact of the clear aligners orientation on %ΔRa during the CVS is higher than other process parameters. Results demonstrate that cyclohexanone produces more uniform surface quality with a 92.73% reduction in surface roughness compared to methylethylketone and toluene on PETG, i.e., 89.66% and 88.63%, respectively. The developed surface finishing method is capable of producing uniform, smooth surfaces over the FDM-fabricated PETG clear aligners.